Home
About
                                         Us
Projects
What's
                                         New
Inventory
Products
Contact
                                         Us
Slitting Lines

Previous

Next

 

Up

Equipment No. . 

SLT-72-0.135/1

Manufacturer . 

Herr-Voss

 

Description . 

72" Slitting Line

 

Manufactured .

1994

 

Drawings . 

-

 

Photos . 

 Photos

Specifications


SLITTING LINE

HERR VOSS 72 SLITTER 1994

Introduction: This equipment is designed to receive, load, payout, gauge thickness, cut crop, slit, scrap wind, strand extend or multi tension, separate, recoil and deliver steel coils.

Coil specification:

Material: Cold rolled steel, hot rolled steel, coated, painted, stainless steel and Aluminum

Thickness: 0.015 Minimum -- 0.135 Max.

Width: 72 max.

Yield: 50,000 PSI at max. Thickness

Shear strength: 55,000 PSI at max. Thickness

Entry/Exit Coil I D: 20/ 24 Nominal

Entry Coil O D: 84 Max. 36 Min.

Exit Coil O D: 84 max. 33 Min.

Weight: 60,000 Lbs Hand: Right (Direction)

2 speed line: 500 FPM with coil build-up to 900 FPM

1200 FPM

Jog/ thread speed: 50 FPM

Gauge control: Loral, entry side

AC power supply: 460 Volt / 3 phase/ 60 Hz

Control voltage: 115 V AC/ 1 phase/ 60 Hz

Air pressure (reqd): 125 PSI max. 60 PSI operating

Hydraulic power unit: 2 units Entry and Exit

25 HP motors

Pumps 32 GPM @ 1500 PSI

If you didn't find what you are looking for, or need further information on a specific item,  email us.

[Home] [About Us] [Projects] [What's New] [Inventory] [Products] [Contact Us]

367 Mansfield Avenue, Pittsburgh, PA 15220 USA
Tel: (412) 928-2880 | Fax: (412) 928-2881

1999 Sherman International Corporation. All rights reserved.

Please contact our Webmaster with questions or comments.