Home
About
                                         Us
Projects
What's
                                         New
Inventory
Products
Contact
                                         Us
Structural Mills

Previous

Next

 

Up

Equipment No.  

STR-Bar Mill-500,000/1

Manufacturer . 

Davy United

 

Description . 

500,000 Bar and Section Mill

 

Manufactured .

-

 

Drawings . 

 

Photos . 

 
 

Specifications


 

    Bar  mill was commissioned in May 1968.

    Stage 2 of the mill was commissioned in late 1973.

    The mill was designed by Morgan Construction Co. of the USA and built by Davy United of England.

    The mill hot –rolls billet into medium range Merchant bar for use in Engineering, Automotive, building

    And Fabricating Industries and for export.

    PRODUCTS:

    Rounds-                                                16mm-100mm

    RoundCoils-                                          19mmto 33mm

    Squares-                                               16mm to 40mm

    Billets-                                                  45mm to 75mm

    Hexagons-                                            20mm to 63mm

    Deformed Bar –                                     20mm to 50mm

    Beam ( Taper flange) -                           100mm x 45mm

                                                                125mm x 65mm

    Channels ( parallel range) -                   75mm x 40mm

                                                                100mm x 50mm

                                                                125mm x 65mm

    Equal Angles-                                       90mm x 90mm

                                                                100mm x100mm

    Unequal Angles                                     100mm x 75mm

                                                                125mm x 75mm

    Flats                                                     75mm to 200mm wide

                                                                & 8mm to 75mm thick

     

    Roof Bolt                                              20mm

                                                                21.7 mm

                                                                21.9mm

    The billet length used varied from 9.4m to 12.1m according to the product produced, as does the billet cross section.

    Billet cross section dimension  used were:

    121mm x 121mm , 127x127mm and 175x175mm

    The finishing speed of the mill varied from 2 mps for large sections and up to 14mps for small sections.

    The product was either hot coiled ( 1219mm OD x 864mm ID) or straight and cut to customer lengths (4.5m to 18m)

    At the product shears before bundling and shipping , according to customer’s requirement.

    Bar Mill production was processed into many products such as

    Springs( coil, leaf and rail clips) shock absorber , piston rods,

    transmission gears, High tensile shafts and fasteners and steering racks.

     

     


If you didn't find what you are looking for, or need further information on a specific item,  email us.

[Home] [About Us] [Projects] [What's New] [Inventory] [Products] [Contact Us]

367 Mansfield Avenue, Pittsburgh, PA 15220 USA
Tel: (412) 928-2880 | Fax: (412) 928-2881

©1999 Sherman International Corporation. All rights reserved.

Please contact our Webmaster with questions or comments.